cars10 Posted July 9, 2018 Share Posted July 9, 2018 So I bought the Commander Pro and am quite pleased with it, however when I create a custom curve and set a fan speed of 0 rpm at 35c, it does not really stop the fans. It is actually quite erratic. If I edit the curve again but essentially change nothing (change something > change it back > apply) it will "listen" once again and shut off the fans, but after a few minutes they will spin up again to my next temp point (300rpm @ 40c). Running 4x ML 140's and 4 ML 140 RGBs in PWM mode (4 of them with 2 PWM-Y cables). The 4 fans that are connected to PWM-Y splitter cables never stop at all. does anyone know why this is happening and how to get it to properly listen? Thanks in advance! p.s. Already tried the iCue software as well (this software doesn't listen either, and stops the fans a lot less within its erratic behavior) Link to comment Share on other sites More sharing options...
DevBiker Posted July 10, 2018 Share Posted July 10, 2018 I think that this is something that they are working on for iCue. Which version of iCue did you try? Link to comment Share on other sites More sharing options...
cars10 Posted July 10, 2018 Author Share Posted July 10, 2018 I think that this is something that they are working on for iCue. Which version of iCue did you try? the latest. Just tested it this week. Corsair, if you are reading this, please FIX this feature! It is even clearly advertised in your videos! I can stop the fans if I set the setting to "Disconnected" in the Link software, so the fan curve should just trigger that! Shouldn't be too hard to do :) [ame] [/ame] Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.