Yoshubi Posted December 28, 2019 Share Posted December 28, 2019 (edited) Hi there guys, I’m looking for some advice on what I need to improve my RGB build. You can see from the picture what I have but I want to add 2 new fans on the bottom of the case and also replace the fan at the top. I also want to buy the 4x led strip pack to put on the back of my monitors so the real question is what do I need for all of this to work properly ie commander pro/hub/lighting node Thanks Image: https://ibb.co/4g1FkKM Edited December 28, 2019 by Yoshubi Link to comment Share on other sites More sharing options...
cjames19 Posted December 31, 2019 Share Posted December 31, 2019 How many slots do you have left open in your commander Pro? Do you want LED strips on the inside of your case or only behind your monitor, or both? I think you may run into an issue where you don't have enough slots to plug in the fans as there is only 6 ports available. But i do see a picture of your case on the corsair website with 8 fans and LED strips, im assuming this is the look you are going for. So it defiantly can be done. Make sure you go for the LS100 lighting kit for your monitor lighting as the Lighting PRO expansion kit is intended for inside the case. Link to comment Share on other sites More sharing options...
Yoshubi Posted January 1, 2020 Author Share Posted January 1, 2020 Hi thanks for the reply, I don’t own the commander yet but sounds like I need that then. Yea I’m looking to add two LL120 fans to the bottom of the case so 8 RGB fans in total. Good about about the led lights Link to comment Share on other sites More sharing options...
Recommended Posts