IJuanTM Posted May 2, 2020 Share Posted May 2, 2020 (edited) Hi, I just bought the Lighting Node Pro with the RGB strips and installed it in my PC. first I ran into the problem that they didn't work but ICue did see them. Turned out to be a bad cable.. Off to a good start... Now they are working properly and I set up the Node in ICue with 4 strips as I have all 4 strips in order from Left -> Bottom -> Right -> Top. Now when I put it to any static mode it obviously works fine. As well as for the Sequential and Visor, it just works fine. See examples here: https://imgur.com/a/1Xxe4qB But when I set it to Color Wave I see that it is off. The wave which should transfer nicely from one to the other does this fine on the ones that are connected to each other. But when it goes from the 4th to the 1st you see that it starts way too early. This also slightly happens on the Rainbow Wave, but not nearly as much as with the Color Wave. I hope there is a sollution for this as Color Wave is the main animation I use and this is kinda annoying. I just recently reinstalled ICue aswell so I don't think that will fix it... Hope to see your reactions! - IJuanTM Edited September 23, 2020 by IJuanTM Link to comment Share on other sites More sharing options...
Recommended Posts