View Single Post
  #1  
Old 04-11-2016, 10:12 AM
Kingp0dd Kingp0dd is offline
Registered User
 
Join Date: Apr 2016
Posts: 3
POST ID # = 846677
Kingp0dd Reputation: 10
Default H100 no LED light and fans not working

I've had my H100 for 4 years now and had no problems with it.

I replaced my thermal paste so I:
- cleaned old thermal paste off the H100 backplate using paper towel and 70% alcohol
- did the same to processor
- put back the H100
- plugged the 3pin fan connector to H100 power slot in the wrong position

Reference image of H100 controller, not actual: http://i.imgur.com/mwhKtjL.jpg

Correct positioning of 3pin fan connector:
o x x x
What I did was:
x x x o

x: used pin
o: unused pin

I noticed that my temps were higher than before I replaced the thermal paste so I went to check what's wrong.

It is only by this time that I noticed the LED lights on the H100 controller are off the fans not working. After that, I tried the following:

1. Correctly replugged the 3pin connectors to the right slots
2. Removed all fans from H100 controller

Both attempts didn't make the controller light up again.
Do you think that this killed the H100?

Last edited by Kingp0dd; 04-11-2016 at 11:04 AM.
Reply With Quote