View Single Post
Old 07-10-2019, 12:04 PM
corsican corsican is offline
Registered User
Join Date: Feb 2019
Posts: 54
POST ID # = 1010783
corsican Reputation: 10

Originally Posted by jonnyguru View Post
Guys... it was a conscious decision to only report one temperature from the PSU.

The PSU does measure multiple temperatures from multiple points within the PSU, but that is for the PSU to know! Not the user!

We found that with reporting multiple temperatures, many users would freak out on the really high ones, wonder why the fan still wasn't spinning when one reading was higher than the other, etc. So it was determined that the temp probe that reports the "ambient temperature" of the inside of the PSU housing would be the best to report.
alrite so when PSU load increases (eg. run prime95 & furmark at same time) how come PSU sensor #2 (the one reported by CLink) barely goes up? it stays around 35C maybe an extra C or so

on the other hand sensor #1 (the one not shown by CL) goes up by about 7C
Reply With Quote