View Single Post
  #1  
Old 11-13-2018, 08:10 PM
SinisterDev SinisterDev is offline
Registered User
SinisterDev's PC Specs
 
Join Date: Dec 2015
Location: NJ (colloquially known as HELL!)
Posts: 29
POST ID # = 980346
SinisterDev Reputation: 10
Default Commander Pro RGB strips not working!

Hello,

So a couple months ago I got my Obsidian 500D RGB SE all setup. Ive got 6 LL rgb fans connected to it and haven't had any issues with them after getting it all setup.
I finally got around to picking up the 4 strip expansion and connected them today. I daisy chained 3 strips together, connected them into the lighting 2 port on the CoPro. I went into the iCue software, enabled port 2, set it to RGB strips and 3 strips.... Nothing..

I made sure the firmware and software were up to date. Ive done multiple resets now, trying everything from 1 strip to 3 strips, swapping strips and connectors just to rule out a possible defective strip or wire, but it just seems like the 2nd port simply isn't sending any juice to the strips.

This whole setup is relatively new. Fans and their rgb leds have been working great. Any ideas? I highly doubt that all 4 of these strips are bunk, so all i can think of is that the 2nd port isn't working... Wish I had a volt meter to test
Reply With Quote