View Single Post
  #1  
Old 02-12-2019, 07:37 PM
michicago44 michicago44 is offline
Registered User
michicago44's PC Specs
 
Join Date: Feb 2019
Posts: 4
POST ID # = 993916
michicago44 Reputation: 10
Default RM650x - Some Cables Missing Pins. Normal?

Hi all,

First time builder here. I set up my build yesterday and plugged everything to the PSU and was able to use my PC fine for a few hours. However, I noticed on a couple cables that pins were missing in the ends, and no wires were being fed into them. Just want to make sure that's intended.

The two I notice that are missing pins are as follows:

1) The PCIe cable that plugs in to my GPU (the weird looking one that splits into 2). The 8-pin end that plugs into the PSU (says "Type 4" on it) is missing the lower left pin/wire, yielding 7 pins in an 8 pin slot on the PSU. There is also a much shorter 6+2 end (says PCIe on the 6 pin part) that when combined would be not missing a pin. I'm wondering if I should use that end instead of the 8 pin.

2) The peripheral cable that plugs into my HDD, fans, etc (the one with multiple SATA connectors on it in series). The 6-pin end that plugs into the PSU (also says "Type 4" on it) is missing the bottom middle pin/wire, yielding 5 pins in a 6 pin slot on the PSU.

Again, everything was working fine when I tested it out, and I can't imagine these are defects. I've searched around and got mixed results with similar posts - some people saying it's fine and others being skeptical.

Any help would be appreciated. Thanks!

Last edited by michicago44; 02-12-2019 at 09:10 PM.
Reply With Quote