Jump to content
Corsair Community

I have an issue about vengeance RGB pro


TDA1541

Recommended Posts

Hi Corsair,

 

My icue version is 3.21.88 and I have vengeance RGB pro Light Enhancement Kit*4 + vengeance RGB pro 8G*4

 

If I enable full software control there is two DIMM will lost light.::pirate::

THX3iNq.jpg

 

But when disable full software control will light normally.

T2cHMlb.jpg

Link to comment
Share on other sites

Hey, hey!

 

Are the effects under Full Software Control applied to the DIMMs that are not lighting up?

 

When you flip between the two, the Lighting Effects are different and may need to be recreated/applied.

Link to comment
Share on other sites

Ohh~

That's my negligence. Thanks your help.

 

But I still have other problem, I have enable "Start on system startup" then I will lost 4 lightning bar in iCue after PC power on. Restart iCue service can't fix this problem, only close iCUE.exe and run it again can fix.

 

Power on

TawrZg9.jpg

 

Close and run it again

rlty7vl.jpg

Link to comment
Share on other sites

×
×
  • Create New...