View Single Post
  #10  
Old 09-17-2019, 09:36 AM
n0ahg n0ahg is offline
Registered User
 
Join Date: Jun 2019
Posts: 21
POST ID # = 1018450
n0ahg Reputation: 10
Default

I have almost 11 cm the width but the problem would be the height. The cable management bar would prevent installation on bottom fan and only allow about 120mm height from the bottom of the top fan. The option might be to remove the cable management bar as it's an all black case.

The RTX 2060 FE can be dismantled, I've seen that video which is why I knew about the glue, but I don't think you can get a water block for it due to the difficulties and because it doesn't run that hot (160W with only one 8 pin PCI-E to power it). The fans on my second card still make an annoying noise though (RMA'd one already due to fan noise) :-(

Edit: Oooops, only 11cm width... that would be including the radiator so no go.
Edit2: I've found a water block and the glue looks like it's just for the ribbon cable so not too bad, none is left holding the actual card after the ribbon cable is removed.

Last edited by n0ahg; 09-21-2019 at 12:09 PM.
Reply With Quote