View Single Post
  #6  
Old 05-27-2008, 10:29 AM
DerekT's Avatar
DerekT DerekT is offline
Registered User
DerekT's PC Specs
 
Join Date: Jul 2005
Location: White Rock, British Columbia
Posts: 10,168
POST ID # = 350313
DerekT Reputation: 10
Default

Quote:
Originally Posted by brenbren View Post
set the mobo to optimized defaults. and saw that it had changed the setting to 0.

i wrote it down this time, it was called the refresh to ACT delay. if that means anything.
0 is correct. I would perform a fresh install of the OS to clear up any file corruption.
Download memtest from---> Here
and extract the ISO image. Burn the ISO image to an CD-ROM disk.

Enter your BIOS. On the main BIOS screen press Ctrl + F1. You will see the screen flicker. Next select the MB Intelligent Tweaker option. On that screen you will see many additional settings that were not there before.

Quote:
MIB Intelligent Tweaker (M.I.T.)
CPU Clock Ratio = 9
CPU Host Clock Control = Enabled
CPU Host Frequency (Mhz) = 357Mhz
PCI Express Frequency = 100Mhz
C.I.A.2 = Disabled
System Memory Multiplier = 2.3
DRAM Timing Selectable = Manual
CAS Latency Time = 4
DRAM RAS# to CAS# Delay = 4
RAS# Precharge = 4
Precharge Delay (tRAS) = 12
ACT to ACT delay = Auto
Bank Write To READ Delay = Auto
Refresh to ACT Delay = 0
Read to Precharge Delay = Auto
Memory Performance Enhance = Normal
Dimm OverVoltage Control = +.3V
PCI-e OverVoltage Control = Normal
(G)MCH OverVoltage Control = +.02
CPU Voltage Control = Auto
Robust Graphics Booster = Auto
Run Memtest for two full passes, then (If Stable), enter Windows and post screenshots of CPU-z's CPU, Memory and SPD tabs.

Last edited by DerekT; 05-27-2008 at 10:34 AM.
Reply With Quote