The Corsair User Forums  

Go Back   The Corsair User Forums > Search Forums

Showing results 1 to 25 of 10000
Search took 0.36 seconds.
Search: Posts Made By: c-attack
Forum: Cases 01-23-2020, 11:27 PM
Replies: 1
Views: 15
Posted By c-attack
You won’t be able to do 2x280 with anything else....

You won’t be able to do 2x280 with anything else. Those two can do any of the three sides in combination, but not take a 3rd radiator (aside from a token 120/140). If you want three, you have to do...
Forum: iCUE Software 01-23-2020, 09:14 PM
Replies: 2
Views: 23
Posted By c-attack
All fans have a minimum speed. The ML should be...

All fans have a minimum speed. The ML should be around 400 rpm. The LL will be 600 rpm.

On the H115i Plat controls in iCUE, keep bumping up the % until you find the start trigger. Most fans are...
Forum: iCUE Software 01-23-2020, 07:07 PM
Replies: 2
Views: 30
Posted By c-attack
1)The prior generation Asetek partner coolers...

1)The prior generation Asetek partner coolers would display half the pump speed. If it is displaying erratic or doubled up values, it is likely a software reading problem. Make sure you have set...
Forum: Cooling 01-23-2020, 06:57 PM
Replies: 1
Views: 20
Posted By c-attack
Good chance it will be since both the H100x and...

Good chance it will be since both the H100x and H100i XT have the same OEM partner. Not all Corsair coolers can utilize the same backplate bracket, but chances are these two can. That said, the XT...
Forum: iCUE Software 01-23-2020, 05:20 PM
Replies: 2
Views: 23
Posted By c-attack
Can you confirm you are on the proper software...

Can you confirm you are on the proper software profile and iCUE is running when this happens? It is theoretically possible for the actions list become corrupted, overwritten, or something similar,...
Forum: Keyboards and Mice 01-23-2020, 04:04 PM
Replies: 3
Views: 40
Posted By c-attack
Yes, unfortunately the side thumb rest is not...

Yes, unfortunately the side thumb rest is not removable on the Nightsword. However, while I disliked it on the Glaive, I find it comfortable on the Nightsword. Not sure where you are located. In the...
Forum: Memory 01-23-2020, 11:15 AM
Replies: 1
Views: 30
Posted By c-attack
When you put your PC into S3 sleep or other...

When you put your PC into S3 sleep or other standby modes, the system state is stored in the RAM. You can't remove power to it like a normal LED. The easiest solution is to set the system to...
Forum: Keyboards and Mice 01-23-2020, 11:11 AM
Replies: 3
Views: 40
Posted By c-attack
The Nightsword might be comfortable. It is...

The Nightsword might be comfortable. It is middle sized, with a natural set-up for palm grip, but also works with a semi-claw or finger tip....
Forum: iCUE Software 01-23-2020, 11:02 AM
Replies: 4
Views: 55
Posted By c-attack
Yes, if you connect the fan wires to the...

Yes, if you connect the fan wires to the Commander Pro instead of the cooler, then their speed will register on the C-Pro. There is nothing connected to the cooler, so 0 rpm.

You probably want...
Forum: Hydro X Custom Cooling 01-23-2020, 10:52 AM
Replies: 9
Views: 83
Posted By c-attack
It is an OEM replacement part and likely only...

It is an OEM replacement part and likely only available through Corsair -- other than in the ML140-RGB form, but that is changing the game a bit. Regardless, you could compare the ML140 OEM part...
Forum: Cooling 01-23-2020, 10:46 AM
Replies: 6
Views: 78
Posted By c-attack
It should run faster than that for your specified...

It should run faster than that for your specified curve. Click the Fixed % and set it to 75% to see if it responds.

Aside from that, the previous question about other monitoring software is still...
Forum: Cooling 01-23-2020, 10:41 AM
Replies: 4
Views: 63
Posted By c-attack
I don't think you will find any performance...

I don't think you will find any performance difference between a ML120 and NF-F12 of any flavor. The industrial 2000 or 3000 rpm version only has a statistical advantage when you are running at...
Forum: Cooling 01-22-2020, 10:36 PM
Replies: 2
Views: 32
Posted By c-attack
You are trying to get the inlet/outlet tubes...

You are trying to get the inlet/outlet tubes above the CPU block so the bubbles float up and out of the pump. For most installations, that means lifting the front of the case and so measure of...
Forum: Hydro X Custom Cooling 01-22-2020, 08:54 PM
Replies: 2
Views: 46
Posted By c-attack
No and the Hydro X curves definitely are not...

No and the Hydro X curves definitely are not programmed for balance. It is strictly a radiator/cooling specific calculation. This is one of several reasons why I don't advocate for zero rpm use. ...
Forum: Cooling 01-22-2020, 08:49 PM
Replies: 7
Views: 86
Posted By c-attack
I'd give it more time. There isn't any reason...

I'd give it more time. There isn't any reason for the A14i and F12i to use a different PWM circuit and they likely have the exact same motor.
Forum: Cooling 01-22-2020, 06:24 PM
Replies: 7
Views: 86
Posted By c-attack
That depends on which side you want to say is at...

That depends on which side you want to say is at fault. Apparently there is a little less standardization in PWM signals than you would think. The other Industrials work (save the 2000 PWM on the...
Forum: Cooling 01-22-2020, 02:34 PM
Replies: 4
Views: 63
Posted By c-attack
You are likely to have difficulties. There is...

You are likely to have difficulties. There is also no reason to use them. You won't eek out any more performance from a radiator that thickness/density at those speeds.
...
Forum: iCUE Software 01-22-2020, 10:59 AM
Replies: 6
Views: 209
Posted By c-attack
LOL. OK, I tell them to stop working on that. ...

LOL. OK, I tell them to stop working on that. No one wants motherboard LED integration. Presumably your entire purpose in using Aura to make the RAM LEDs sync with your motherboard LEDs. ...
Forum: iCUE Software 01-22-2020, 09:45 AM
Replies: 6
Views: 209
Posted By c-attack
Are you actually using the Aura-Corsair RAM...

Are you actually using the Aura-Corsair RAM plugin from June 2019?

You may need to get caught up on current events. See the sub-forum below.
https://forum.corsair.com/v3/forumdisplay.php?f=311
Forum: Cooling 01-22-2020, 09:32 AM
Replies: 7
Views: 86
Posted By c-attack
That's correct. The Noctua Industrial F12 and...

That's correct. The Noctua Industrial F12 and A14 3000 RPM PWM versions have a PWM incompatibility with Corsair controllers. That is limited to the 3000 rpm version only, whereas the 2000 PWM...
Forum: Hydro X Custom Cooling 01-22-2020, 09:23 AM
Replies: 2
Views: 68
Posted By c-attack
You can mix any fan type or brand on the...

You can mix any fan type or brand on the Commander Pro. Each port operates independently. However, there are some incompatible PWM configurations that have surfaced. The Noctua Industrial 3000 PWM...
Forum: Cooling 01-21-2020, 10:08 PM
Replies: 6
Views: 95
Posted By c-attack
OK, something is misbehaving and we need to try...

OK, something is misbehaving and we need to try and sort a physical problem with the fan or splitter and a software issue. A few things to try:

1) Swap the two fans on pump splitter 1 <-> 2. ...
Forum: Power Supplies 01-21-2020, 08:13 PM
Replies: 14
Views: 177
Posted By c-attack
It does sit in a funny position within the...

It does sit in a funny position within the families. When I first saw the release, I was very excited we were getting 1000W Titanium, hopefully similar to the 1600i. Then all the AX860i/1200i could...
Forum: iCUE Software 01-21-2020, 08:06 PM
Replies: 3
Views: 103
Posted By c-attack
I don't know. That suggests it might be keyboard...

I don't know. That suggests it might be keyboard related rather than iCUE per se. I would contact Corsair Tech Support through the ticket system. You can also try a soft reset in the interval. I...
Forum: iCUE Software 01-21-2020, 08:00 PM
Replies: 9
Views: 167
Posted By c-attack
Chances are the LS100 is like the QL and not...

Chances are the LS100 is like the QL and not implemented because it's new. However, wouldn't we need a toggle for it so it can be included with the other effects or not and used as video lighting? ...
Showing results 1 to 25 of 10000

 
Forum Jump

All times are GMT -4. The time now is 12:15 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.