The Corsair User Forums  

Go Back   The Corsair User Forums > Search Forums

Showing results 1 to 25 of 9025
Search took 0.42 seconds.
Search: Posts Made By: c-attack
Forum: Hydro X Custom Cooling 09-21-2019, 12:54 AM
Replies: 1
Views: 47
Posted By c-attack
That will be a standard max GPU length - 54mm...

That will be a standard max GPU length - 54mm calculation and then compare it your GPU length. However be aware you will surely lose the most forward top fan if using anything more than a 30mm...
Forum: Hydro X Custom Cooling 09-19-2019, 07:47 PM
Replies: 4
Views: 81
Posted By c-attack
You are going to have to be very precise in your...

You are going to have to be very precise in your observations. The CPU can change temperature in milliseconds and for legitimate reasons. Make sure your CPU load is low and something is not running...
Forum: Cooling 09-19-2019, 06:38 PM
Replies: 5
Views: 91
Posted By c-attack
Yeah, it has gotten really messy with the ML...

Yeah, it has gotten really messy with the ML PRO/LED specs, the RGB and H115i/H150i Pro stock fans, and then the H100i Pro fans that are the same as the ML Pro twin pack grey. However, the bottom...
Forum: Corsair Link 09-19-2019, 06:31 PM
Replies: 7
Views: 70
Posted By c-attack
Also note the Commander Pro can control 3 pin DC...

Also note the Commander Pro can control 3 pin DC or 4 pin PWM and you can adjust individually for each of the 6 fan headers. You could cancel the new fans and put it toward this, if you are looking...
Forum: Cooling 09-19-2019, 06:29 PM
Replies: 4
Views: 98
Posted By c-attack
At idle levels and fan speeds (lets call that...

At idle levels and fan speeds (lets call that 750-800 for 120s and 600-700 for 140s), there isn't going to be any difference. Anything you hear will either be fan or pump and the cooling is all the...
Forum: Hydro X Custom Cooling 09-19-2019, 06:22 PM
Replies: 4
Views: 81
Posted By c-attack
Is the Commander Pro temp your coolant sensor? ...

Is the Commander Pro temp your coolant sensor? The CPU is definitely way above that, but make sure you are viewing that in relation to load. It's hard to find a quiet moment with no activity these...
Forum: Power Supplies 09-19-2019, 06:17 PM
Replies: 1
Views: 42
Posted By c-attack
That depends on if you have any other Corsair...

That depends on if you have any other Corsair peripherals or internal devices. If you have keyboard, mouse, RGB fans, etc., you definitely want iCUE. iCUE is the merger of the two prior programs...
Forum: iCUE Software 09-19-2019, 06:12 PM
Replies: 200
Views: 17,585
Posted By c-attack
And now it is done. iCUE 3.20.80 is up and the...

And now it is done. iCUE 3.20.80 is up and the ugliness of this issue is nowhere to be found. My testing came out incredibly steady and consistent. I think everyone is good to go. Just in case,...
Forum: iCUE Software 09-19-2019, 06:06 PM
Replies: 18
Views: 1,165
Posted By c-attack
It appears to have been fixed. I just finished...

It appears to have been fixed. I just finished 10 consecutive runs of Time Spy 12 (CPU only) and the scores are fantastically precise. Quitting iCUE gets you another token 50-75 points, but that is...
Forum: Cooling 09-19-2019, 12:51 PM
Replies: 5
Views: 91
Posted By c-attack
The fans included with the H150i are the ML120...

The fans included with the H150i are the ML120 "Quiet", which are effectively the same as the ML120-RGB version without lights. Obviously when you reduce the maximum speed from 2400 to 1600, the...
Forum: Cooling 09-19-2019, 11:18 AM
Replies: 2
Views: 47
Posted By c-attack
This is always local environment and hardware...

This is always local environment and hardware specific, so we can't tell you set 700 rpm = 28C. Your coolant temperature (H100i v2 Temp) is the measure of radiator efficiency and the only directly...
Forum: Corsair Link 09-19-2019, 11:14 AM
Replies: 7
Views: 70
Posted By c-attack
iCUE is the replacement program for Link,...

iCUE is the replacement program for Link, specifically the merger of Link (internal devices) with CUE 2 (peripherals). Link has no functionality when iCUE is running and it should give you a message...
Forum: Cases 09-19-2019, 10:26 AM
Replies: 1
Views: 47
Posted By c-attack
The forum part got folded into the margin above...

The forum part got folded into the margin above Hydro X. I forget it is there until I click the "Corsair product discussion" link from the chain above and they all show up at the top. Here is the...
Forum: Hydro X Custom Cooling 09-19-2019, 09:15 AM
Replies: 7
Views: 145
Posted By c-attack
^^^ The suggestion above. Drain it. Fill it...

^^^ The suggestion above. Drain it. Fill it with distilled water. Run it for a few hours. Drain. Refill distilled water. Repeat. Repeat. As often as you can stand. You don't want any more...
Forum: Cooling 09-19-2019, 09:07 AM
Replies: 4
Views: 72
Posted By c-attack
The USB 2.0 is the connection between the...

The USB 2.0 is the connection between the hardware (H150i) and the software environment (iCUE). They have to be physically linked somehow to interact with each other. A H150i or any other "i"...
Forum: Cooling 09-19-2019, 07:46 AM
Replies: 9
Views: 75
Posted By c-attack
I would put the top fans as exhaust to help...

I would put the top fans as exhaust to help remove waste heat from the front radiator as well as radiant heat from the VRM, RAM, etc at the op of the board. No reason to blow that back into the case...
Forum: Hydro X Custom Cooling 09-19-2019, 12:18 AM
Replies: 7
Views: 145
Posted By c-attack
It's possible there is a mild contact issue with...

It's possible there is a mild contact issue with the GPU block. I think most 2080 Ti will hit a GPU diode temp of around 50C when at full voltage with some mild boost, but as always the load is...
Forum: Cooling 09-19-2019, 12:12 AM
Replies: 9
Views: 75
Posted By c-attack
If you already have the 9 LL, then you can...

If you already have the 9 LL, then you can certainly try it. However, I suggest you start with a single layer of fans on the H150, plus the other 3x120 as exhaust in the top/rear. That will keep...
Forum: Cooling 09-18-2019, 09:38 PM
Replies: 9
Views: 75
Posted By c-attack
I think you generally don't get a lot of return...

I think you generally don't get a lot of return on push-pull for 360mm radiators with low wattage to dissipate. That's every CPU out there, 12 cores or not. However, it may offer some improvement...
Forum: Hydro X Custom Cooling 09-18-2019, 09:32 PM
Replies: 10
Views: 727
Posted By c-attack
You don't have to daisy chain them if you have...

You don't have to daisy chain them if you have the RGB channels available. The only difference might be when I set a preset lighting effect, the daisy chained ones automatically go in sequence with...
Forum: iCUE Software 09-18-2019, 09:17 PM
Replies: 6
Views: 140
Posted By c-attack
Any time you create a new profile in iCUE, it...

Any time you create a new profile in iCUE, it will immediately return all fans to default "Quiet" status which is really the same thing as being linked to CPU (core) temp. 1 second later all my fans...
Forum: Cooling 09-18-2019, 09:12 PM
Replies: 9
Views: 75
Posted By c-attack
No chance. 280mm radiators are a bad fit for the...

No chance. 280mm radiators are a bad fit for the top of the 460/570 and you usually collide with some element of the motherboard. You need the skinnier 240mm, which makes sense anyway since that is...
Forum: iCUE Software 09-18-2019, 02:41 PM
Replies: 6
Views: 140
Posted By c-attack
That sounds like CPU core temp is the control...

That sounds like CPU core temp is the control variable. On the manual graph, there will be a box at the top labeled “source”. This is the temp data the program uses in your curve below. The program...
Forum: Memory 09-18-2019, 02:29 PM
Replies: 2
Views: 116
Posted By c-attack
Yeah, I’ve never seen that specific timing set...

Yeah, I’ve never seen that specific timing set either and it does strike me as unusual. However, no reason to jump to conclusions yet. You’re going to need someone from Corsair to check the serial...
Forum: iCUE Software 09-18-2019, 12:39 PM
Replies: 6
Views: 140
Posted By c-attack
Commander Pro Tab -> Settings. Change the LL fan...

Commander Pro Tab -> Settings. Change the LL fan ports from Auto to 4-Pin and see if this brings change. You generally want it set to this anyway so it doesn’t to a fan power test on start-up.
...
Showing results 1 to 25 of 9025

 
Forum Jump

All times are GMT -4. The time now is 02:18 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.