techee Posted January 16, 2020 Share Posted January 16, 2020 (edited) Hey All, I recently purchased a Corsair 570x case along with 6 x LL120's w/ Commander Pro. The build was a lot of fun, and by far my best looking build to date. I took my time and managed all the cables/wires, even labeling all my LL120 connections to ensure they got plugged into my RGB hub and Commander Pro properly. I went to power up my new build, and noticed that all fans light up except the 6th LL120 fan in the RGB hub, but spins. I can see this fan and RPM in the iCue software after selecting LL120 and 6 fans in the "Lighting Setup". So the troubleshooting begins. Troubleshooting Steps Taken: 1. Re-seated LL120 #6 Fan RGB connection to RGB Hub (No Change) 2. Replaced RGB Hub with another from my LL120 3-Pack (No Change) 3. Moved LL120 #6 Fan RGB to Port 5 on RGB Hub (Fixed) 3. Moved LL120 #5 Fan RGB to Port 6 on RGB Hub (Fixed) 4. At this point, all fans 1-6 spin and light up. As soon as I move it back to the original configuration Fan #6 RGB quits working again. Has anyone seen this happen before, and what do you think the issue is? I have updated the firmware on the Commander Pro as well. Thanks. Setup: Edited January 16, 2020 by techee Link to comment Share on other sites More sharing options...
Recommended Posts