The Corsair User Forums

The Corsair User Forums (https://forum.corsair.com/forums/index.php)
-   Cases (https://forum.corsair.com/forums/forumdisplay.php?f=189)
-   -   Standoffs and micro ATX (https://forum.corsair.com/forums/showthread.php?t=187296)

Zwizii 05-05-2019 11:11 PM

Standoffs and micro ATX
 
Hi,

I just bought a corsair carbide spec 05 and I was wondering if you need to install the standoff given with the case if i was installing a micro ATX board. There seems to already be one pre-installed but i dont know.

Edit: there is only one standoff screw that comes with the case

Corsair Caliente 05-06-2019 02:38 PM

Hey Zwizii,

The Spec 05 should have came with pre-installed stand offs. If they're missing from the case you can either set up an exchange or check with our support team for assistance.

Zwizii 05-06-2019 04:37 PM

So i shouldn't need to worry about installing the standoff screw because of the one that comes preinstalled right?

tjgodin 05-07-2019 10:33 PM

Quote:

Originally Posted by Zwizii (Post 1003726)
So i shouldn't need to worry about installing the standoff screw because of the one that comes preinstalled right?

That sounds correct, based on them being pre-installed. I'm assuming you can see the actually pre-installed standoffs on the motherboard tray area - so, they should line up to the holes on your motherboard.

In my Corsair 280x I ended up removing some of the pre-installed standoffs because I had an ITX board and didn't need them all. Though it would have been fine to leave them.

Good luck with your build.


All times are GMT -4. The time now is 08:19 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.