The Corsair User Forums

The Corsair User Forums (https://forum.corsair.com/forums/index.php)
-   Corsair Link (https://forum.corsair.com/forums/forumdisplay.php?f=209)
-   -   Corsair Linknot showing all fans (https://forum.corsair.com/forums/showthread.php?t=183660)

Rainer12 12-19-2018 01:07 PM

Corsair Linknot showing all fans
 
Hey, so I just picked up corsair sp120 rgb fan and plugged it in using its 3 pin to my mobo. Since I dont need its leds for now I didnt plug in the 4 pin led header anywhere (I dont even have hub yet). My question is why isnt it showing in corsair link as fan4 (its connected to sys fan 4 header on mobo).
Link is only showing my 2 other case fans and h100iv2 fans(im assuming #fan1 is h100i because link shows 0rpm under h100iv2 fan)

https://imgur.com/a/C4BnP6O

DevBiker 12-19-2018 04:29 PM

Not sure ... it's hard to say as the motherboards are all different.
I do notice, however, that your cooler isn't powered properly. Please review section B of the Liquid Cooler FAQ linked in my signature. I cannot even begin to stress the importance of this. Your pump speed should never be 720 RPM.

Rainer12 12-20-2018 01:49 PM

Umm is it too much? It's usually between 600 to 1080 which is max. I got it configured like that from a shop.

DevBiker 12-20-2018 03:36 PM

It's too low. Please read the Liquid Cooler FAQ, section B.

Continuing to run the cooler like this will likely cause premature failure. Your shop didn't configure the system properly.

Rainer12 12-20-2018 03:41 PM

Ok so I set cpu fan to always max in bios. I think its properly configured now. https://imgur.com/a/ubkPYVw
I can even see fans rpm under h100iv2 however I dont know what Fan#1 now is.

DevBiker 12-20-2018 06:43 PM

Yes, that Pump speed looks MUCH better. Pumps looks like performance, fans are on quiet or a custom curve, yes?

Fan #1, under your motherboard, looks like it'll be the CPU Fan header. That's reported at about 1/2 of the pump speed.

Rainer12 12-20-2018 08:21 PM

Yes I set it to performance and fans are on a custom curve. Oh you are right, Fan#1 is the cpu fan header. Thank you very much. It still leaves me without my 3rd case fan showing there but Im thinking about getting 3x 120LL or ML fans with hub so I can have my fans show in one place. Thank you once more


All times are GMT -4. The time now is 06:18 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.