Ketanjal

Hey Guys, I've been lurking around for a while on this forum :biggrin:. But now it's time to post a bit here :sunglasse. I have to say Zotty and Devbiker... You guys have helped me out a ton so big shout out to both of you! Since there is no holiday for me in this current COVID situation and I work as an independent contractor (AEC Modelling and Design) it was time for me to invest/play around a bit. So I've built two systems. 1 in a 500D case (Ryzen 3700X build) soft tubing and now started in the 1000D case (Threadripper 3970X build), which I want to do with hard tubing. Already started out getting used to bending and must say I prefer Acryllic over PETG :laughing: For the last one.. My idea was to go double 480 XR7 rads in Push Pull and a 420 XR5 on top also in push pull. Now I've been trying to read through everything and even in the build guide on the HydroX Loop Config... They say you can fit that into here with fans only on 1 side.. Now my question is if anybody has any experience with putting the Front rads in Push Pull and the Top 420 rad in push pull. If so, did it fit with all fans? Or did you have to make space and remove the 2 top fans of the front rads? Since I already have had a derp with 2 140 Fans in the back that didn't fit.. I'd like to not return the 5 QL140's I have :roll: but if the 420 rad will not fit I might have to go 2x360 rad like Zotty did. Hope everybody is healthy and safe in this weird crisis :laughing: Cheers, Ketanjal (editted the thickness of the rads)