Okay, so I am going to undertake this small project possibly this weekend if the stuff shows up.
I currently have 6 LL120 Fans and 4 Corsair LED strips in my setup. I'd like to replace the 40 LED's on the Corsair strips with 96 LED's from the WS2812B LED Strips.
Now when connecting to the Commander Pro I know it has 3 pins, power, data, and ground.
Now when powering the LED Strips I would just give them 5v direct from the PSU and feed them Ground and Data from the Commander Pro, and that's it?
I think that is what I got from reading over these posts, but there is so much info that it gets confusing. I wish someone who's done this project would make a how to video.
If I can get those interior LED strips to work inside the case then I'm going to run a LNP outside the case with a regular usb cable to connect LED Strips on my desk to get those to match my case profiles. I Think that would be pretty neat, but first I just need confirmation on what I stated was correct.
Thanks!