patrikor

Awesome, thanks :)

Hi all, I hope I'm posting this in the right place. I've ordered a Corsair Dominator Platinum Airflow RGB LED Memory Fan (CMDAF2) and I want to control the lighting using one of the lighting channels on my Commander Pro. (I know it comes with a lighting node pro, but I'd rather just use the Commander Pro and not install additional hardware.) My question is, which type of lighting device is this? I have the following options to choose from in the iCUE software: RGB light strip (no) HD RGB series fans SP RGB series fans SP RGB Pro series fans LL RGB series fans ML RGB series fans (thinking no because these fans have a bearing) HydroX series (no) I guess I could just try all the available settings, but does anyone know offhand which lighting type is correct? Thanks!

Awesome, thanks both of you for the help and info.

So (since the h150i is SATA powered) as long as my 6 fans draw less than the remaining 1.55A available to the cooler for fans, I should be good to go?

Hi all, Clearance issues aside (since I know an h150i with NF-A12x25 fans in push/pull will fit in my case), has anyone had any issues with this combination? I'm thinking I just need 3 pwm splitters so that I can control the additional fans. Is that correct? Or do I need to run everything off a Commander Pro? Thanks in advance!

Thanks for your reply. Makes me feel a bit less nervous. :)

Hi all, I'm planning a new build soon, using the 500D SE case and an h150i cooler. I'm planning to use non-RGB mag-lev PWM fans that draw a max current of 0.05 amps. (12v, .6 watts, Noctua NF-F12 chromax.black.swap fans in case it's relevant). I'm planning to run a push-pull setup and have 3 case fans, for a total of 9 fans in the case. What I'd like to know is, am I going to burn out these 0.05A fans if I attach them to the h150i or the CoPro? How do these devices "know" how much current to supply to the fans? I also have a secondary question: For the additional 3 fans in the push/pull setup, should I attach those to the h150i with fan control wire splitters? Or should I connect them to the CoPro? edit: removed a question I found the answer to in a review. Thank you!! Patrick