rmrm

@Terrok On the 4x32GB kit, 3200MHz seems to be the upper bounds of stability. Even though we have similar system specs, I am unable to get stable memory benchmarks in memtest at 3600MHz or 3733MHz. It will also randomly BSOD. I was expecting your scores at 3600MHz+ to be higher than the results I'm getting at 3200MHz. However, I am getting Cinebench R20 scores that are similar to yours even though my memory is slower (3200MHz). If I enable PBO in Ryzen Master, CBR20 reaches 9440 pts. Were you able to do a full pass of memtest without errors at 3733MHz ?

can you post your cinebench r20 multicore and single score while your memory is configured @3800mhz as shown in your screenshot?

what is the version of your ram? I tested 3.xx (4x32gb kit) and 5.49 (2x32gb kit x2) and both were not compatible. The 3950x was not OC. Are the settings in your screenshot the only ones that you changed? Is your memory voltage considered high and are the memory temps over 55C?

In the XFR enhancement screenshot, did you apply any changes and if so are they safe?

I'll test it out 3400MHz. Both of the kits I'm using are by Hynix ( CJR ?). Can someone from corsair confirm if CMW128GX4M4D3600C18 would work on the Aorus Xtreme X570?

Update: 3200MHz is stable on Aorus Xtreme X570, but I thought this board was capable of more, at least 3600MHz which is the default XMP of the ram.

No I don’t think it’s on the QVL since it’s new. I bought 2 of the same kits (2x32GB) totaling 4. Are you recommending to turn on XMP, leave all settings as is, and only change the system memory multiplier to 3200? Will that sync with the infinity fabric settings automatically for it to be 1:1?

I am only getting memory related errors on memtest and BSOD when running 4x32GB with XMP enabled. CMW64GX4M2D3600C18 Aorus Xtreme X570 Did anyone at Corsair verify a setup like this? What should the updated timings be for system stability? Should I increase voltage to 1.4 with XMP enabled? Thank you