Jump to content

boop

Members
  • Posts

    2
  • Joined

Reputation

10 Good
  1. I'll try disabling each fan one at a time as you suggested. However, I did connect the fans using an extender to the cooler (not sure if this is a factor). I believe I did stop all three fans the other day and the system was whisper quiet. It's just I didn't check each individual fan. Also the side of the radiator where I have the ML fans attached to, there are no washers and the side with the LL fans - there are washers attached (can't remember why I did this). Unscrewing the fans - if it came to that... would I then have to remove the cooler off from the cpu and clean the thermal compound and reapply? I'm just assuming there won't be much room to get away with just removing the fans. I'll be sure to update you once I'm home early next week. Thank you for the advice! I'll try disabling one fan at a time using the corsair software to determine which fan(s) are the root cause. Not too keen on replacing the fans at this current time since I've already spent a lot of money on the system thus far. I'll update you once I return home early next week. Thank you for the info!
  2. Hello, I've recently just built my first computer and the 3 fans (ML 120mm) that came with my Corsair H150I PRO RGB cooler are making loud noises/vibrations even at low RPM. I'm not sure if I built the computer wrong or if it's a defective fan(s). My setup is as follows: Corsair h150i radiator side mounted to case (500D RGB SE). 3 fans ML 120mm that came with the cooler are attached to the front of the radiator with corsair logo showing at the front. 3 LL120 fans attached to other side of the radiator with corsair logo visible inside case. 3 fans ML 120mm fans connected to H150i pump 3 way splitter cable. H150i connected to CPU_FAN header with PWM mode enabled in motherboard bios. H150i usb port cable header connected to commander pro. Commander pro connected to usb header on motherboard. LL120 fans connected to rgb hub which the hub then connects to the commander pro. I apologise for the newbie wording. I'm new to the world of pc building
×
×
  • Create New...