GhostWorks

Does anyone one know when cases will come with "iCue Link" rather than the older commander. I'm planning on upgrading my 900D case as its been 10 years now . time for a new case and new build no point spending 500+ on the 1000D when removing commander etc to make it all iCue Link

I believe its not related to icue software more hardware issue as its same during boot before icue was even installed on a rebuild with new RAM , I have 3 leds out on 2 sticks for 2 x 64GB kits , also don't want to RMA just yet as its new and most likely will just get another with same issue

Just bought 2 x 64 GB kits ( CMT64GX4M4C3200C16W ) and one LED is in a different colour than the rest , hope its a firmware or software issue and will be resolved soon

will run Riser cable from The Rampage VI extreme Third Slot down with is 16x which should give me enough length

Thanks for the reply and the pic does help confirming, any issue with length on the PCIe riser cable been in the way of the other PCIe slots ? Good looking build by the way

Has anyone here installed their GPU at the Vertical slots for the mini-ITX board location for the main system so that the other PCIe slots are still available for other devices like the Asus Hyper raid 16x card etc I currently have the 900D and am thinking of upgrading to 1000D Rampage Vi Extreme Asus Strix 2080 GPU Intel Optane 280Gb PCIe Asus HyperX16 Raid I'd imagine putting a GPU at that location with a Corsair HyperX GPU water cooler would look nice as closer to the window than the other option

I'm looking at upgrrading my case from 900D to the new 1000D Has anyone mounted the GPU vertically at the location for the mini-ITX graphics card location, as want to use other PCIe lanes for Intel Optane PCIe 480Gb , Asus Hyper 16 raid etc