knives88

Hi all, I have a problem with iCUE 4.xx.xxx and the HX850i sensors. In the menu of HX850i sometimes i see the graphs and sometimes not. In the dashboard are fixed only the sensors that can be seen in the photo, if i make any changes, at startup return in the old positions.

I currently have a Carbide AIR 540 and would like to replace it with a Crystal 680x. The case is installed under a closed desk on the top and left side, so I adopted a negative pressure configuration with excellent results: - Top: 2x140 Exhaust (AIO) - Front: 3x120 Exhaust - Rear: 1x140 Intake - Botton: None The Crystal 680x has tempered glass on the front and top, do you think it can create problems with the air flow?

I have to install H100i Platinum on a motherboard without internal USB 2.0 ports (broken), can I use any Micro USB cable> USB to be connected to a USB port on the back of the motherboard?

Ok thanks to both, tomorrow I will go to buy it. I never used the Sniper button, mostly because on the M65 Vengeance it is too far from my thumb and I have to move my hand forward. I have also tried the M65 PRO and in fact it is not very comfortable to put my thumb on the Sniper button.

After almost 6 years of honorable service (still working but very consummate) the time has come to change my old M65 Vengenace. I found myself very well as a constructive form, I'm thinking of switching to the M65 Elite which is practically identical, but since I can't keep iCUE (other monitoring programs) open all the time, it is possible to save the various DPI / Polling Rate / Angle Snapping values, etc. in the mouse memory and then uninstall iCUE? With the M65 Vengeance it could be done with CUE I hope it is still possible. Thank you P.S. I noticed that the sniper button has been moved further back so that it is pressed without a thumb problem, does it bother you?

With Corsair Service active, can't monitoring AIO/PSU with other program like SIV/Hwinfo ( just tried with HX850i + H150i Pro ). So if I uninstalled iCUE I lose the settings stored in the aio?

When I set the various parameters of the AIO I will only open iCUE and once removed I will only use Hwinfo.

Is the problem completely solved by setting a static color and closing iCUE + service or do I also have to disconnect the USB cable? I would always keep it connected with Usb Cable to monitor pump speed / temp. liquid through HwInfo.

I have only read all the threads now regarding the problems of the new H150i PRO firmware. In my case fortunately it was successful and with firmware 1.04 and iCUE 3.6.109 everything works without problems for several days.