NecroMan Posted December 4, 2018 Share Posted December 4, 2018 Hello! I have a 2 issues with my Corsair config (Commander Pro, Lighting Node Pro, 5 LED strips, 3 LL120 fans, 3 HD140 fans and some peripherals). 1. iCUE software constantly says there is an update for my LNP - 0.5.104. After update it shows the same version of current firmware. 2. LNP didn't work as it should after my PC returns from sleep mode. Connected to it LED strips stops to react on iCUE settings and shows default rainbow effect. LL and HD fans connected to Commander Pro starts to "lag" - their effects not so smooth as it should. If I stop iCUE then fans starts to work smooth again. All start to work OK only after I reboot my PC. P.S. My LNP USB connector connected to CP. P.P.S. Sorry for my english :) . Link to comment Share on other sites More sharing options...
NecroMan Posted December 9, 2018 Author Share Posted December 9, 2018 Life hack for this situation: 1. Remove LNP from Devices and Printers. 2. Add LNP through searching devices in Device Manager. After that iCUE works normally. Except it says LNP has a new firmware 0.7 :) . Link to comment Share on other sites More sharing options...
NecroMan Posted December 12, 2018 Author Share Posted December 12, 2018 Any support here? :) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.