shannonjpower Posted June 10, 2016 Share Posted June 10, 2016 Hi, Whilst removing my Corsair Link over to another case I accidentally damaged the cable that runs from the Link to the LED controller etc. 2 of the pins have come out of the small plastic end connector. The very left hand one and the also the second from the left (pins 1 and 2 highlighted in the diagram). Can someone please confirm that the pin layout is the same at both ends as shown in the diagram? As in pin 1 goes in the same spot in the opposite connector and so on without any wires crossing over? http://i66.tinypic.com/33uzt51.jpg http://i68.tinypic.com/21en9s2.jpg I'd love to try the Link again after sitting unplugged for all these years. Thankyou. Link to comment Share on other sites More sharing options...
red-ray Posted June 10, 2016 Share Posted June 10, 2016 I'd love to try the Link again after sitting unplugged for all these years. Yes, I confirm you are correct. What CL hardware do you have? CL4 does not support the old Link Commander. Link to comment Share on other sites More sharing options...
shannonjpower Posted June 10, 2016 Author Share Posted June 10, 2016 Ouch well that puts a damper on things. I have the original release Link, cooling node and lighting node. It's been sitting unplugged in my system for a couple of years now. Guess it's a no go :bigeyes: Thank you for confirming that for me tho, much appreciated. Link to comment Share on other sites More sharing options...
red-ray Posted June 10, 2016 Share Posted June 10, 2016 Ouch well that puts a damper on things. This is what I guessed and I feel for CL4 not to support the old commander is rather poor. In my SIV utility the extra code needed to support the old commander is < 30 lines of C and I just can't understand why CL4 does not support it :confused:. Have you read http://forum.corsair.com/forums/showthread.php?t=137428? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.