L003sgh Posted February 10, 2016 Share Posted February 10, 2016 Trying to install my H100i GTX in the top of my 750D case. However, with the rubber grommets on the case and then the washers that come with the H100i the screws are to short and will not reach the radiator...if I don't use the washers they reach....but not using the washers is probably not a good idea...has anyone else had this problem? Are there some different screws I should be using? or somewhere to get some longer ones? Link to comment Share on other sites More sharing options...
DeathAngel74 Posted February 12, 2016 Share Posted February 12, 2016 I just had to replace my H100i GTX due to pump failure. I went to Ace Hardware and got (8) 6-32 x 1 1/4 screws. The screws mount the radiator to the 300R, while securing the fans, if you want push/pull setup. http://imgur.com/AcG9rou Link to comment Share on other sites More sharing options...
c-attack Posted February 12, 2016 Share Posted February 12, 2016 6-32 machine screw in the necessary length is right size. You can get these at any hardware store. Specialty screws are not needed. I haven't noticed complaints on the 750D before, but it is impossible to account for the chassis thickness of every model out there. If the screw won't reach with the washer but will without, it is still too short. Try to estimate the length you need or get multiple lengths. You can probably get a 4 pack for $1-2 depending upon location. You also are going to need 8 more anyway if you want to mount the fans in push exhaust. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.