Jump to content
Corsair Community

H60 3 pin power, 100% or not?


killer121

Recommended Posts

hi guys

so i have just got a new h60 in my system with a asus z77 board n a 3770k

 

I have connect the 3 pin power connector onto one of the board's 4pin fan header

 

i was wonder should i turn the "Q- fan" controller on or off on the 4pin header, so that it will ramp down when idle or running at full speed.

 

will lower rpm benefit the life of the product or should i just set it to run 100% anyway?

 

Thank guys

Link to comment
Share on other sites

hi guys

so i have just got a new h60 in my system with a asus z77 board n a 3770k

 

I have connect the 3 pin power connector onto one of the board's 4pin fan header

 

i was wonder should i turn the "Q- fan" controller on or off on the 4pin header, so that it will ramp down when idle or running at full speed.

 

will lower rpm benefit the life of the product or should i just set it to run 100% anyway?

 

Thank guys

 

Just connect the pump to the 3 pin power connector and not to the 4 pin chas-fan 1 on the MB so it will run at full rpm because the power header is not controlled by the Asus Q-fan controller. I do not hear my pump at full rpm.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...