luckyhitaki Posted March 5, 2018 Share Posted March 5, 2018 Hi I purchased the one some weeks ago. After finally having set-up everything, i was going to play some Heroes of the Storm. However when I set the resolution in the 2560x1440, approx after 5 min, I start to lag and weird particles flash and disappear. The game keeps running normal afterwards but some of the ingame control disappears. Unfortunately I dont have any other games currently to try out, so i downloaded the demo of 3d mark. The test crashes approx around second 27 of the test. As I was unable to complete a full test, i downloaded furmark. When I switched to the desktop to check if c-link is showing the same temps (50c) as c-link, this happened: [ame] [/ame] and the pc crashed. i deinstalled and reinstalled the graphics drivers. But 3dmark is still crashing at 27 seconds and i am scared to test furmark again. what should i do? thx for the support Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted March 5, 2018 Corsair Employee Share Posted March 5, 2018 In BIOS, try changing the PCIe setting to Gen2 and see if that resolves it. Otherwise, you should contact our support team. Link to comment Share on other sites More sharing options...
luckyhitaki Posted March 5, 2018 Author Share Posted March 5, 2018 https://imgur.com/a/6opsK Hi Thank you for the quick response. I am unable to find the setting that you are refering to, can you route me through? thanks! Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted March 5, 2018 Corsair Employee Share Posted March 5, 2018 https://imgur.com/a/6opsK Hi Thank you for the quick response. I am unable to find the setting that you are refering to, can you route me through? thanks! I see that you're in the newer BIOS revision that enables this by default. If you had the option available it'd be as follows: Settings -> Advanced -> PCI Subsystem Settings -> PEG0 - Max Link Speed You'd then change from Gen3 to Gen2. At this point, I'd suggest talking to our customer support team. Link to comment Share on other sites More sharing options...
luckyhitaki Posted March 5, 2018 Author Share Posted March 5, 2018 thank you! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.