nfanis Posted April 24, 2018 Share Posted April 24, 2018 Using XMP Profile i get no Post even after the latest bios Update I can get post up to DDR4-4000MHz Currently running this kit @ 3200 14-14-34 CR2 is it better to leave it like that or push it to 4266 CL19? Link to comment Share on other sites More sharing options...
emissary42 Posted April 24, 2018 Share Posted April 24, 2018 If DDR4-4000 is the top end of what your board can handle, I would try to tweak that ratio for max performance. Usually DDR4-4000 16-16-16 is no problem for kits like yours at or even below 1.40V. Link to comment Share on other sites More sharing options...
nfanis Posted April 25, 2018 Author Share Posted April 25, 2018 If DDR4-4000 is the top end of what your board can handle, I would try to tweak that ratio for max performance. Usually DDR4-4000 16-16-16 is no problem for kits like yours at or even below 1.40V. Tried DDR4-4000 16-16-16-45 but gives me memtest errors i tried up to 1.5v any ideas on timmings? Link to comment Share on other sites More sharing options...
emissary42 Posted April 25, 2018 Share Posted April 25, 2018 My torques @ 4000 16-16-16, they do need 1.42V for that: Your kit should probably need less voltage for the same settings. Otherwise try to go up one or two steps with the timings to 17-17-17 or 18-18-18 and keep memory voltage at around 1.4V. Link to comment Share on other sites More sharing options...
nfanis Posted April 25, 2018 Author Share Posted April 25, 2018 My torques @ 4000 16-16-16, they do need 1.42V for that: Your kit should probably need less voltage for the same settings. Otherwise try to go up one or two steps with the timings to 17-17-17 or 18-18-18 and keep memory voltage at around 1.4V. Thanks for your help 18-18-18@1.40v did the trick no errors in memtest and passed 1h realbench test Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.