James7679 Posted January 13, 2018 Share Posted January 13, 2018 Firstly, after installing a LNP and CoPro, I was alerted to an update. I tried applying the update and the installer crashes. Next, I don't see any area for the temperature probes. Finally, I don't see all of the fans, nor do I seem to have any control over them, beyond the Quiet, Balanced, or Performance options. Link to comment Share on other sites More sharing options...
James7679 Posted January 13, 2018 Author Share Posted January 13, 2018 I was able to update by shutting down Afterburner and Riva. All probes are showing now. Fans are also showing now, kinda; two come up, then there's four, sometimes six, but it mostly shows only two fans. All fans seem to be working otherwise. Link to comment Share on other sites More sharing options...
DevBiker Posted January 13, 2018 Share Posted January 13, 2018 Are you running any other monitoring software? The behavior that you are describing sounds a lot like you are running either HWInfo or HW Monitor. Link to comment Share on other sites More sharing options...
James7679 Posted January 13, 2018 Author Share Posted January 13, 2018 It was indeed Hwinfo64. I shut it down and restarted the PC and all was well. One more thing; is there a way to shut off each fan channel completely? I forgot to note which fan is on which channel and I'm finding it hard to assign them properly. Link to comment Share on other sites More sharing options...
DevBiker Posted January 13, 2018 Share Posted January 13, 2018 Yes. Set it to Fixed % / 0 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.