Sockerbyxa Posted October 20, 2014 Share Posted October 20, 2014 Hi. ive just purchised a commander mini and i have a question regardning the temp monitoring on my cpu. It's red and sometimes the temp shows for a few seconds and back to red again, over and over. I know its the wrong forum for this but maybe someone can give some advise on this anyways. Ive just watercooled my system and i have EK pwm pump and a z77ia-S01 m-itx mobo. Ive connected the pwm pin from the pump to the commander, hoping that i could control the pwm signal in Link. I hade the pump conected to the cpu fan header first but i couldnt control it their either. That is my questions, why are the temp for the cpu show red and 0 celsius in temp and sometime show the "correct" temp. And where to connect my pump so that i can control the pwm signal Link to comment Share on other sites More sharing options...
wytnyt Posted October 20, 2014 Share Posted October 20, 2014 im not saying you could try a fan header to control the pump assuming the power for the pump is low enough for the mini,,but,, the mini is designed for fan control and not so much for pumps. Link to comment Share on other sites More sharing options...
Sockerbyxa Posted October 21, 2014 Author Share Posted October 21, 2014 the pump is powered by molex and have a cable for pwm. EK states that the pump can be controlled by CPU fan header or a dedicated fancontroller Link to comment Share on other sites More sharing options...
Corsair Employee Corsair Dustin Posted October 21, 2014 Corsair Employee Share Posted October 21, 2014 Are you using this version of Link? http://forum.corsair.com/v3/showthread.php?t=132837 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.