#of Fans per channel on Commander pro

Hi everyone I was considering purchasing the Commander pro but I have 9 corsair ll120 fans in my case. my question is, can I connect 2 corsair ll120 fans via PWM splitter to one channel. I read the commander pro supply's 1A to the fan ports and the ll120 fans draw .30A, would that work. Thank you for your time.

Yes, you can. I know that Zotty has his set up like that. Personally, I have 2 HD fans on one channel as well.

I don't think it's 1A total; I think it's 1A per connector.

Thank you for your reply. I am going to buy the commander now.

Here's my setup, btw. I have a total of 7 fans on the Commander Pro:

just to add to this.... i asked this question directly to corsair and the answer was 'although not officially supported it should handle it no problem'.. i have 8 fans on my commander, 2 fans on channel 1 and 2 fans on channel 2. single fans on the rest (and 2 on the h100i v2.),, no issues thus far.. of course they only appear as single fans in link ;)..

I got an Anidees AI Cube Lite for Xmas from the wife. Here’s my plan. LL140x2 on the front, LL120x4 up top, a LL120 rear exhaust and lower base blowing on M.2. The on left side of case 3x80mm and a 92mm (Zalman) exhaust. Going to try and wire all 8 LL’s to my CLCP. Post when it’s done after Xmas (hopefully).