thrasher_565 Posted October 11, 2018 Share Posted October 11, 2018 so im going to do a power mode so i can turn off all the leds at once off of my fans. i just looked up what the sata power uses and it has 3 ground and 3.3v, 5v, and 12v. so what power dose the commander pro use and lighting node and led hub? looks like the cp uses all 5 wires and the lighting node uses 4 wires and the hub 2 wires now i sound out the there is a double throw single switch that's basic 2 switch in one. for the cp i would need to disconnected all 3 of them? so i need a triple throw signal switch. double throw single switch for the node and signal switch for the node? i wounder how i can do it so i control all of them with 1 switch. looks like i need at lest an 6 throw signal switch (witch i be leave they make) hmm what if i attach all my led stuff to a second psu and just power that on and off... Link to comment Share on other sites More sharing options...
DevBiker Posted October 11, 2018 Share Posted October 11, 2018 You can attach it to a second PSU. The Commander Pro uses the following rails: - 3.3V: Powers the MCU - 5V: Powers USB and any RGB Strips connected - 12V: Powers the fans The Lighting Node Pro uses: - 3.3V: Powers the MCU - 5V: Powers any RGB Strips connected The RGB Fan Hub uses: - 5V: Powers the fan RGB LEDs. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.