Jump to content
Corsair Community

Dominator on 1st channel, Vengeance on 2nd?


lyunardo

Recommended Posts

Hi,

I bought a Dominator 16GB, 3200MH, 2x8 kit to replace a Vengeance 3000MHz kit that had gone bad.

Since then, I got the Vengeance kit (also 2x8) replaced via RMA.

My question: can I use all 4 sticks simultaneously as long as I keep them on separate channels?

My mb is a Gigabyte ga-z170mx-gaming 5.

Thanks,

Link to comment
Share on other sites

I've always installed identical RAM in the same system, but these sticks have the same voltage and, so far, work just fine together.

 

The clock speed is so close that I don't notice a difference. Although it's possible that the Dominator chips will run at 3200 MHz since they're running on their own channel.

I only have a couple applications that will use more than 16GB.

 

I'll have to dig deeper, and do some benchmarks.

Link to comment
Share on other sites

  • Corsair Employee
Hi,

I bought a Dominator 16GB, 3200MH, 2x8 kit to replace a Vengeance 3000MHz kit that had gone bad.

Since then, I got the Vengeance kit (also 2x8) replaced via RMA.

My question: can I use all 4 sticks simultaneously as long as I keep them on separate channels?

My mb is a Gigabyte ga-z170mx-gaming 5.

Thanks,

 

May be an issue, may not. No way to know without continuous use.

 

-Art

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...