wingman1659 Posted February 10, 2011 Share Posted February 10, 2011 Ok yeah I got a little antsy when setting up my SSD. I was converting from a RAID1 setup and set my SATA settings back to IDE mode while installing Windows. My question is can I update my F60 to 2.0 while still in this mode and set SATA back to AHCI when my system resets and all will be well? Or is something more drastic needed like reinstalling Windows. (If a reinstall is needed can I just ghost my drive?) Link to comment Share on other sites More sharing options...
Yellowbeard Posted February 10, 2011 Share Posted February 10, 2011 Ok yeah I got a little antsy when setting up my SSD. I was converting from a RAID1 setup and set my SATA settings back to IDE mode while installing Windows. My question is can I update my F60 to 2.0 while still in this mode and set SATA back to AHCI when my system resets and all will be well? Or is something more drastic needed like reinstalling Windows. (If a reinstall is needed can I just ghost my drive?)Read the PDF and the main post for the 2.0 update. The info you need is already there. ::pirate:: Link to comment Share on other sites More sharing options...
wingman1659 Posted February 10, 2011 Author Share Posted February 10, 2011 Thank you! after trying a few different combinations, I finally figured out my wrongs. All had to do with how I had my BIOS set and nothing to do with the firmware. My bad. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.