Jump to content
Corsair Community

Obsidian 500D RGB SE - Motherboard installation


Hayena

Recommended Posts

Yesterday I've finally received my 500D RGB SE but during the installation of my motherboard I noticed the connectors on the back were off.

 

The case came with plenty of screws but the installation guide is really lacking on... well installation.

 

So with the case came a few rubbers which would allow me to raise the motherboard but none of the screws seem to be long enough to do this.

 

Can anyone help me with this? Am I missing something?

Link to comment
Share on other sites

  • Corsair Employee
Yesterday I've finally received my 500D RGB SE but during the installation of my motherboard I noticed the connectors on the back were off.

 

The case came with plenty of screws but the installation guide is really lacking on... well installation.

 

So with the case came a few rubbers which would allow me to raise the motherboard but none of the screws seem to be long enough to do this.

 

Can anyone help me with this? Am I missing something?

 

You're going to have to be more specific, or at least provide some visual, I'm not sure what you are talking about.

Link to comment
Share on other sites

Sorry if I was not clear in my original post, I hope these following pictures make my issue more clear.

 

http://i68.tinypic.com/21nnomf.jpg

As you can see the connectors and the backplate are not aligned properly

 

http://i65.tinypic.com/105scr4.jpg

These are the screws and rubbers provided with the case

Link to comment
Share on other sites

Sorry if I was not clear in my original post, I hope these following pictures make my issue more clear.

 

http://i65.tinypic.com/105scr4.jpg

These are the screws and rubbers provided with the case

 

Those screws and rubbers is not for the motherboard, they should be fitted in the two hdd-trays on the backside. What you can fit in the trays with those screws and rubbers do i not figured out yet.

Link to comment
Share on other sites

  • 3 months later...
Those screws and rubbers is not for the motherboard, they should be fitted in the two hdd-trays on the backside. What you can fit in the trays with those screws and rubbers do i not figured out yet.

 

can you tell me what those screws placed at upper left corner are for ?

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...