DevBiker Posted May 19, 2019 Share Posted May 19, 2019 Hey ... just saw all of your updates. How was the pinout wrong? Did you have +5V and Ground reversed? I'm surprised that this would take out a CoPro but can absolutely see it killing some LEDs. Link to comment Share on other sites More sharing options...
jwilds1 Posted May 25, 2019 Share Posted May 25, 2019 Yes, by wrong pinout I mean I had the 5v and ground reversed. All I know is that the new Commander worked. Thanks a lot for your help! Here's what the end result looks like - 2 strips on each PC, each with 60 LEDs per. I set my PC up with Wall paper Engine and an iCUE audio responsive wallpaper. I then sent audio and video via NDI over to the other rig, with the same wallpaper. The result is a disco. That's not how I usually have it set up, just wanted to see how far it could go. Link to comment Share on other sites More sharing options...
DevBiker Posted May 25, 2019 Share Posted May 25, 2019 Sweet!! Very nicely done! Link to comment Share on other sites More sharing options...
davidgoult1001 Posted June 5, 2019 Share Posted June 5, 2019 Not sure if the the correct place to post this hello so before i start - i have read most of the thread The CLNP + CLCP can control other 5V WS2812B addressable 5050 RGB LED Strips, few time but i still want to ask this as i dont want to brick my CLNP. So want i would like to do is make longer strips without having the black plugs like the corsair strips do. So from what i have read, i would like to make - 5050 rbg strip of 60 leds of 2 meters on one channel of the CLNP and a second Length of 45 leds or 1.5 meters on the second channel. Now i would like to do this with out running the +5v thru the power supply if that is possible. Any help or wisdom on this matter would be greatly appreciated. Link to comment Share on other sites More sharing options...
DevBiker Posted June 5, 2019 Share Posted June 5, 2019 That would work. You need to keep it to 60 LEDs or less on a single channel and you've done that. Link to comment Share on other sites More sharing options...
nightxmarez Posted June 21, 2019 Share Posted June 21, 2019 Hey there everyone, new here. I have a Barrow distroplate with a built in led strip. It uses a 3 pin 5v connection. Could anyone assist me in making this connect to my icue setup, or perhaps make an adapter for me? Link to comment Share on other sites More sharing options...
Recommended Posts