Kriegripper Posted January 12, 2016 Share Posted January 12, 2016 Hey just got my k95 and I'm wondering if there is a way to assign a g key to switch profiles so I wouldn't have to go in the program and manually change it. -Rex Link to comment Share on other sites More sharing options...
LoStDr3aM Posted January 13, 2016 Share Posted January 13, 2016 Of course you can! You can setup your gkeys to switch profiles and modes (M1-M2-M3) as much you want! Link to comment Share on other sites More sharing options...
krazykid Posted January 13, 2016 Share Posted January 13, 2016 In assignments you right click the key you want to set as the mode switch and youll be given with plenty of options. Link to comment Share on other sites More sharing options...
shankstar Posted September 18, 2016 Share Posted September 18, 2016 Does anyone have a walkthrough on how to Assign a key for Profile Switching in CUE 2? I can set it up but I can't seem to get it to say which key is the correct one. I can't seem to find this problem anywhere else and everything i find leaves out how to get it to work. Link to comment Share on other sites More sharing options...
brainless Posted September 18, 2016 Share Posted September 18, 2016 Does anyone have a walkthrough on how to Assign a key for Profile Switching in CUE 2? I can set it up but I can't seem to get it to say which key is the correct one. I can't seem to find this problem anywhere else and everything i find leaves out how to get it to work. See picture: 1. select Action 2. press + 3. select Profile switching 4. select a key to use for profile switching 5. add your profiles to the list 6. press Assign Link to comment Share on other sites More sharing options...
shankstar Posted September 18, 2016 Share Posted September 18, 2016 Thank you Brainless! Item 4 was stumping me but I should have known it would work just like Key assignments. Much appreciated. Link to comment Share on other sites More sharing options...
Kisendi Posted October 7, 2016 Share Posted October 7, 2016 See picture: 1. select Action 2. press + 3. select Profile switching 4. select a key to use for profile switching 5. add your profiles to the list 6. press Assign Thanks for this step by step guide. You have no idea how infuriated I was that I was unable to swap profiles because it wasn't as clear as to HOW to assign a button as it was in CUE 1. Then again it was probably just me being too simple. Once again, Thank you!! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.