LawyerLynn Posted January 11, 2014 Share Posted January 11, 2014 Ok, just built a new system. Has an H80i cooling system and 2 sticks of Dominator Platinum ram. I notice that where I plug the 'Y' cable that connects the H80i's 2 fans to the pump system there is a 2nd plug that is not used. Would it be possible to connect the Dominator RAM directly to that connector and monitor the temp or anything in the Link software without the need of the airflow pro setup? I really don't want to cover up the RAM sticks themselves. The look amazing as they are and as soon as the light bar upgrade arrives, they'll look even better. Covering them over with a fan and the airflow pro system is something I don't want to do in my windowed case. Link to comment Share on other sites More sharing options...
wytnyt Posted January 11, 2014 Share Posted January 11, 2014 i agree as i have DM and couldnt bring myself to watercooling the memory,unfortunately the air flow fans are needed to monitor the memory.. Link to comment Share on other sites More sharing options...
bee144 Posted January 13, 2014 Share Posted January 13, 2014 i agree as i have DM and couldnt bring myself to watercooling the memory,unfortunately the air flow fans are needed to monitor the memory.. That information is incorrect. You need the AirFlow Pro unit to measure DIM temp. Link to comment Share on other sites More sharing options...
wytnyt Posted January 13, 2014 Share Posted January 13, 2014 That information is incorrect. You need the AirFlow Pro unit to measure DIM temp. i was quoting one of Ramguys reply to the same asked question quote And in order to use the Link software with these modules you would have to purchase an Air Flow Fan and Air Flow Pro. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.