Daniel Stone Posted August 15, 2016 Share Posted August 15, 2016 Hey, I built the bulldog yesterday. Completed the build started it up and installed Windows 10 Pro. After installation I went to install all the drivers from the included USB thumb drive, to my surprise the drive was not recognised by the system and appeared completely blank. Am I doing something wrong? Cheers Link to comment Share on other sites More sharing options...
howard42 Posted September 10, 2016 Share Posted September 10, 2016 You are not alone. Link to comment Share on other sites More sharing options...
howard42 Posted September 10, 2016 Share Posted September 10, 2016 The instruction manual also needs some improvement. Some steps are missing or in wrong order. I had to go back and forth a few times to complete the build. Also really want an accessory that can turn the left side into bottom side so that the case can be in vertical orientation. After all, I'm happy with the design and performance. Link to comment Share on other sites More sharing options...
TaterT0t Posted September 15, 2016 Share Posted September 15, 2016 I had to go backwards as well during my build but now I can't remember why. Also there is no mention anywhere in the instructions of when to install a M.2 drive. Now that I think about it that may have been what got me. I can't remember if it is under the motherboard or not that comes with the bulldog. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.