Yolobro Posted October 20, 2017 Share Posted October 20, 2017 Hello guys!! anyone using vengeance rgb 3000mhz CL15 (8gx2) with asus b350 rog strix? I was trying so hard to get 2933mhz but it seems impossible to get that value! I tried with DOCP failed Manual input value list 16-17-17-17-37 1.35v failed 18-18-18-18-38 1.35v failed 19-19-19-19-39 1.35v failed 20-20-20-20-40 1.35v failed I can't even guess right now so frustrating is this ram just not possible to get 2933?? any help will be very much appreciated Link to comment Share on other sites More sharing options...
technonotice Posted October 30, 2017 Share Posted October 30, 2017 I have the same mobo and the 4gb per module version of the ram what works for me is to manually enter the timings after setting docp 15-17-17-17-35-52, then set ProcOCdt at 53.3 ohms and memory voltage at 1.3650v. It also helps to set a soc voltage increase of 0.03125v and VTT DDR voltage at 0.6850v. I have two identical rig's one will post at 2933mhz whereas the other will only post at 2800mhz. Link to comment Share on other sites More sharing options...
framed123 Posted October 31, 2017 Share Posted October 31, 2017 I have the exact same model and it works perfectly for me with docp, but I can't get the ram's rgb sync with aura Link to comment Share on other sites More sharing options...
Xrat3d Posted November 17, 2017 Share Posted November 17, 2017 I have the exact same model and it works perfectly for me with docp, but I can't get the ram's rgb sync with aura Hey man, dumb question, but can you change the colors using Corsair Link? Link to comment Share on other sites More sharing options...
Corsair Employee Corsair CJ Posted November 17, 2017 Corsair Employee Share Posted November 17, 2017 There's a chance you might have to enable SPD Write in the BIOS. Check to see if it's set to "enabled". AURA/CL4 should then be able to address the RAM. Link to comment Share on other sites More sharing options...
TRYSTER Posted November 27, 2018 Share Posted November 27, 2018 Use 16-17-17-17-35 as your clocking you should hit 1500mhz exact. And also upgrade your bios it may not have the right drivers. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.