Jump to content
Corsair Community

K90 and 2.12 re-install


Miyano

Recommended Posts

Hi,

 

I bought the K90 couple of months ago, installed the 2.12 drivers, updated the firmware and it worked fine. Now, I've build a new computer and can't install the 2.12 drivers (getting the "can't find M90, plug the M90 in a USB port" error message). I've disabled the USB selective suspend setting as was suggested in an other post, but it still refuse to install.

 

I assume the beta driver installer is working for all vengeance products even though its named "M90 setup beta2.12 010612". The error message refers to the M90 too which is a bit confusing. Is this supposed to work for the K90?

 

Any idea what's going on?

 

Thanks.

Link to comment
Share on other sites

The control panel software is the same for both devices but it won't recognize the K90 if you install the M90 version and vice versa. I've got exactly the same issue you described with my K90, it just won't recognize it no matter what.
Link to comment
Share on other sites

Uninstall all software and kill all process related to both of your devices.

 

Re flash the firmware:

 

Install software.

 

Any link for the firmware updater? And I have only one device: K90.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...