FeeNiX Posted December 13, 2018 Share Posted December 13, 2018 Anyone found a way to connect the CLNP or Commander outside the computer temporarily while I work on effects behind a custom front plate I am building? I have a a powerbrick going to a SATA power cable from some old hard drive external adapters, but I cannot seem to find a cable that will connect to the CLNP or Commander to my computer external USB ports for control. My understanding is that both of these devices require a connection to a 9 pin USB motherboard header. I have found cables that go USB A to 5pin motherboard header plug, but not 9 pin. It would be a lot easier for me to work on mocking this up if I was able to test effects while it was out on the workbench. Any help? Link to comment Share on other sites More sharing options...
DevBiker Posted December 13, 2018 Share Posted December 13, 2018 For the lighting effects, you can use a single USB A to 5pin motherboard header plug. You'll plug this into the row with only 4 pins ... so you'll need to skip over one of the pins. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.