H100i LED Mixing Problem (very odd)

Well my H100i was purchased in March and now I'd say its been nearly a month since I noticed that my white LED setting is now bright pink. Now I thought like most people here that had the problem, an LED might be blown out. However, this is what I've done so far in the software:

 

-red 100 green 0 blue 0 - red

-red 0 green 100 blue 0 - green

-red 0 green 0 blue 100 - blue

-red 0 green 100 blue 100 - same as blue 100 (not cyan)

-red 100 green 0 blue 100 - pink

-red 100 green 100 blue 0 - pink (flickers yellow twice, but then stays pink)

 

Everything at zero turns the led off which is good, but for some reason i have to do this every time i turn my system on which is annoying.

 

So I'm not sure what's going on as it seems mixing green is an issue, but the LED's are working just fine.

 

Note that I have also updated my firmware to 1.0.7, as well as the corsair software i reinstalled using the one on their website.

 

Is there a fix for this kind of issue or is this a straight RMA case?

 

Thanks

sounds like a firmware issue, pic processor or whichever they used. I would bring it to their attention and skip rma. A firmware update would resolve. could also be a bad flash. Try re-updating. I don't have this product myself, but going by my technical skills. Firmware Flashing has never been 100% for me

sounds like a firmware issue, pic processor or whichever they used. I would bring it to their attention and skip rma. A firmware update would resolve. could also be a bad flash. Try re-updating. I don't have this product myself, but going by my technical skills. Firmware Flashing has never been 100% for me

 

That's good then, I shall bring this to Corsair's attention and hopefully this fixes it. Thanks!