Frosty4652 Posted March 11, 2018 Share Posted March 11, 2018 Good afternoon! Could you help me in solving the problem? Suddenly, while the computer was working, the fans started to misunderstand themselves, the program had a choice of all Duga fans, they all began to glow differently, like a software failure, eventually checked everything, everything was connected to the controllers, there were new controllers that never connected, changed them but the problem did not dare! Now just like that, there is a fan running, at any time a podvetchetsya podstvetka at any of the 6 fans, View all images http://prntscr.com/ipp25u http://prntscr.com/ipp28p http://prntscr.com/ipp2b1 :Сумасшедший: Link to comment Share on other sites More sharing options...
DevBiker Posted March 11, 2018 Share Posted March 11, 2018 Hello! Fortunately, my wife understands Russian (a little dated as she left in 1980) but it was enough to help me understand. I would suggest that you start with re-arranging the fans on the fan hub. The fans operate in a series and 1 fan can take out the entire chain. Put 1 fan on the first port on the fan hub and see if that operates properly. If so, add the second fan. And so on. However, just because a single fan works does not mean that it will pass the signal down the line to the next fan so remember that as you are reordering them. Link to comment Share on other sites More sharing options...
Frosty4652 Posted March 12, 2018 Author Share Posted March 12, 2018 Hello! Fortunately, my wife understands Russian (a little dated as she left in 1980) but it was enough to help me understand. I would suggest that you start with re-arranging the fans on the fan hub. The fans operate in a series and 1 fan can take out the entire chain. Put 1 fan on the first port on the fan hub and see if that operates properly. If so, add the second fan. And so on. However, just because a single fan works does not mean that it will pass the signal down the line to the next fan so remember that as you are reordering them. All reconnected, earned only 2 fans Link to comment Share on other sites More sharing options...
Frosty4652 Posted March 12, 2018 Author Share Posted March 12, 2018 If you connect the first 3 in reverse order, then the first 3 pieces work, 4 is already not lit as needed, and 5 is not lit at all, 6 is the same. That is, only the first 3 ports work and so on all the connectors that I tried Link to comment Share on other sites More sharing options...
Frosty4652 Posted March 12, 2018 Author Share Posted March 12, 2018 It turned out to connect them in a chaotic order, they work 5, but not in order, and the last 6 on the front panel still does not work, that is, does not take the effect of Arc Video https://drive.google.com/open?id=1tGM8IczTSB0vy69m8WrBqaUCYSxKI3BB Link to comment Share on other sites More sharing options...
DevBiker Posted March 12, 2018 Share Posted March 12, 2018 It looks like one of your fans is bad. i would contact support to see if you can get it replaced. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.