ccl3no2 Posted December 22, 2014 Share Posted December 22, 2014 Hello! to all Corsair world! I have a little problem with the PSU AX1500i. I explain: In my office we recently have bought this PSU and it works excellent! Our reseller has changed the motherboardand processors to update the computer but...! The new motherboard has the 24+8+8+4 connectors: one 24 pin, 2 EPS 8 pin and one ATX 12V 4 pin. Damn! The AX1500i has only the 24 pin and 2 EPS 8 pin. Is there any chance to adapt some other connector (like a molex) or any other way to have available also the 4 pin ATX one? Thank you very much! Link to comment Share on other sites More sharing options...
William1 Posted December 22, 2014 Share Posted December 22, 2014 LOL, I had similar concerns. Look at the mother board 8 pin cable. It separates! Plug the once in and leave the other section alone. :) Link to comment Share on other sites More sharing options...
Corsair Employee jonnyguru Posted December 23, 2014 Corsair Employee Share Posted December 23, 2014 You don't need all three power connectors. They all go to the same circuit. Using just the two 8-pin connectors should be more than enough. The 4-pin is there for people that have a more typical PSU with one 8-pin and one 4-pin. Link to comment Share on other sites More sharing options...
ccl3no2 Posted December 23, 2014 Author Share Posted December 23, 2014 OK, thank you! I'll try to connect only the pair of 8 pin EPS connectors. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.