View Single Post
  #6  
Old 09-21-2012, 07:38 AM
Mnpctech.com's Avatar
Mnpctech.com Mnpctech.com is offline
Registered User
 
Join Date: Nov 2009
Posts: 465
POST ID # = 603781
Mnpctech.com Reputation: 10
Default

Thank you for your comment, joejoe69

Quote:
Originally Posted by ZeroKateo View Post
Very nice, How many fan grommets did you need?
16x, but you can use washers instead of the grommets. I stated this in my guide

Quote:
Originally Posted by ZeroKateo View Post
Also does it matter what blade is on the vertical saw?
Use whatever cutting tools you have access to.. I used a vertical saw for straight line cuts.

Quote:
Originally Posted by ZeroKateo View Post
And do you have to have that drill bit or is it just recommended?
You don't have to use that bit, but you risk cracking the window with normal bit.

Quote:
Originally Posted by ZeroKateo View Post
Also when you were cutting this, did you trace a line onto the paper and then cut along the line or did you use the original window as a guide for the blade?
I traced the factory window dimensions onto the sheet. I stated this in my guide, under the photo.

Quote:
Originally Posted by ZeroKateo View Post
Could you have rounded the corners with a vertical saw or is it recommended to do it by hand with a file?
It's optional, as stated under the photo of the hand file

Quote:
Originally Posted by ZeroKateo View Post
Also where did you get your plexiglas from?
You can buy Plexiglass sheets at Home Depot or Lowes, in the Window section. I prefer the clarity and durability of "Cast Acrylic" which you can order online here

Last edited by Mnpctech.com; 09-21-2012 at 07:59 AM.
Reply With Quote