View Single Post
Old 01-21-2019, 11:29 AM
DevBiker's Avatar
DevBiker DevBiker is offline
iCue βeta Team Green
DevBiker's PC Specs
Join Date: Feb 2017
Location: Republic of Texas
Posts: 6,338
POST ID # = 990819
DevBiker Reputation: 83

How you wire it depends on if it's the last device on the hub or if you want more on there.
On the fan side ...
Pin 1 => +5V, Pin 1 on the strip.
Pin 2 => Data Return (back from device). If it's the last device, you don't need to connect this. If not the last device, splice with Pin 3.
Pin 3 => Data Out (to device). This will connect to Pin 2 on the strip.
Pin 4 => Ground. This will connect to Pin 3 on the strip.

I actually have 24 strips running off of two RGB LED Fan Hubs (12 per hub, 6 per port). If mixing with LL fans, you'll need to watch the number of LEDs. You can place the strip either on the end or in the front. If in the front, splice pin 2 and pin 3 together so that it duplicates the signal to the next device.
Please click "Edit System Specs" and fill out your system info.

This comment is provided "as-is", without warranty of any kind, express or implied, including, but not limited to, the sanity or mental fitness of the author. The author is not a Corsair employee, does not represent Corsair, and no comment should be construed as an official statement from Corsair.

Reply With Quote