View Single Post
  #3  
Old 11-30-2018, 05:18 AM
JejeLaPelle JejeLaPelle is offline
Registered User
 
Join Date: Jul 2017
Posts: 49
POST ID # = 982861
JejeLaPelle Reputation: 10
Default

Hello,

Today i will introduce the watercooling part.

Obviously, the first thing is to thanks again my sponsor EKWB (and Atila) for all this mighty stuff!



As you might see, there is a Velocity block inside, i rushed on it, and really, the block is really cool (even without water)



I placed pumps :





Quite fun to see how it fit with the sketch :



Then the huuuuuge res... the tubbing is a bit different from the 3d model, but like this, res will play better there role of bubble trap :







I also did a small wood plate, but here is only a tease, i got to finish it... :



I also milled flow meters, since EK do not provide such things yet :





Wheel is 3D printed with EK logo on it. Those flow meter will be used as pass throught on the right side, above the 360mm rads.

And few words for the RGB build wich lighted up for the last time :





All the block were super clean after one year of use





I'll be back ASAP for a post on sleeeeving!

Thanks for reading.
Reply With Quote