The Corsair User Forums  

Go Back   The Corsair User Forums > Search Forums

Showing results 1 to 25 of 6103
Search took 0.28 seconds.
Search: Posts Made By: DevBiker
Forum: Memory 02-17-2019, 12:39 AM
Replies: 1
Views: 35
Posted By DevBiker
You either need to enable software control of the...

You either need to enable software control of the memory (in settings) or select "Multicolor" as the effect.
Forum: Cases 02-17-2019, 12:38 AM
Replies: 2
Views: 40
Posted By DevBiker
That's not how they work and you may damage the...

That's not how they work and you may damage the fans or the fan hub by connecting it to that motherboard header. The case should come with a push-button controller for the SP-RGB fans.

Check out...
Forum: iCUE Software 02-16-2019, 11:36 PM
Replies: 1
Views: 37
Posted By DevBiker
That signal comes from the cooler. It provides a...

That signal comes from the cooler. It provides a fan tach signal based on the pump to prevent a CPU Fan warning on boot. Also, in the event of a complete pump failure, you won't get any signal ......
Forum: Cooling 02-16-2019, 12:13 PM
Replies: 3
Views: 87
Posted By DevBiker
What vCore are you actually running (not the BIOS...

What vCore are you actually running (not the BIOS setting ... what's the reading)?

Also, it sounds like you are pushing your GPU heat through the radiator. This will heat it up; there's no way...
Forum: Cooling 02-16-2019, 12:10 PM
Replies: 23
Views: 349
Posted By DevBiker
The Node and the H115i actually only need a...

The Node and the H115i actually only need a single USB port, even though they consume a full header with two ports. The CoPro needs both ports - if they had them as separate, it would increase the...
Forum: iCUE Profiles 02-16-2019, 11:27 AM
Replies: 2
Views: 70
Posted By DevBiker
Depends on the device, which you haven't listed. ...

Depends on the device, which you haven't listed.
For fans, strips and some mice and keyboards, you can do hardware lighting.
Forum: Cooling 02-15-2019, 10:20 PM
Replies: 2
Views: 62
Posted By DevBiker
Did you configure the Lighting Channel in iCUE?...

Did you configure the Lighting Channel in iCUE? You need to do that and that is separate from the Commander Pro "seeing" the Fan RPM.
Forum: Cooling 02-15-2019, 10:19 PM
Replies: 5
Views: 77
Posted By DevBiker
You'll be fine with the LL fans. The Ryzens do,...

You'll be fine with the LL fans. The Ryzens do, as a whole, run a bit warmer than the Intels but not incredibly so.
Forum: Cooling 02-15-2019, 07:16 PM
Replies: 5
Views: 77
Posted By DevBiker
The fans on the H100i RGB Platinum are high-speed...

The fans on the H100i RGB Platinum are high-speed ML-RGB fans, not LL.

As to why they have the Special Edition with the higher speed only in white ... can't say. Obviously a product marketing...
Forum: Cooling 02-15-2019, 05:35 PM
Replies: 9
Views: 475
Posted By DevBiker
Try setting a static color.

Try setting a static color.
Forum: Cooling 02-15-2019, 05:34 PM
Replies: 1
Views: 51
Posted By DevBiker
I would connect them to the pump. That way they...

I would connect them to the pump. That way they can be controlled based on the pump temperature whether iCUE is running or not.
Forum: Corsair Link 02-15-2019, 04:07 PM
Replies: 2
Views: 77
Posted By DevBiker
If the fan curves are run off of the built-in...

If the fan curves are run off of the built-in temperature sensors on the CoPro, it should still work.
Forum: iCUE Software 02-15-2019, 09:18 AM
Replies: 3
Views: 62
Posted By DevBiker
Ah, that one, you can't do. Apparently, there's...

Ah, that one, you can't do. Apparently, there's no onboard storage or smarts that would allow that to work on the MM800.
Forum: Corsair Link 02-15-2019, 08:56 AM
Replies: 13
Views: 2,005
Posted By DevBiker
What I do is slide them under the fans and use...

What I do is slide them under the fans and use the fans to hold them in place. A little bit of electrical tape (in the wire) would work as well.
Forum: iCUE Software 02-15-2019, 08:51 AM
Replies: 3
Views: 62
Posted By DevBiker
Yes. On each channel, go to the "Hardware...

Yes. On each channel, go to the "Hardware Lighting" and set that to what you want.
Forum: Solid State Drives (SSD) 02-15-2019, 01:22 AM
Replies: 3
Views: 112
Posted By DevBiker
M2A is the best option.

M2A is the best option.
Forum: Solid State Drives (SSD) 02-14-2019, 07:39 PM
Replies: 3
Views: 112
Posted By DevBiker
There are several Aorus z390 motherboards. Please...

There are several Aorus z390 motherboards. Please be more specific.
Forum: iCUE Software 02-14-2019, 07:28 PM
Replies: 6
Views: 190
Posted By DevBiker
No, iCUE cannot control the fans through the...

No, iCUE cannot control the fans through the JCORSAIR header. Only through a Lighting Node Pro or Commander Pro.
Forum: Corsair Link 02-14-2019, 07:24 PM
Replies: 1
Views: 73
Posted By DevBiker
Yes, you can. Check out Zotty's 1000D Build Log -...

Yes, you can. Check out Zotty's 1000D Build Log - http://forum.corsair.com/v3/showthread.php?t=180073.
Forum: Cooling 02-14-2019, 10:57 AM
Replies: 2
Views: 100
Posted By DevBiker
The 3-pin connector will connect just fine to a a...

The 3-pin connector will connect just fine to a a 4-pin header. Connecting the pump provides a tach signal to the CPU_FAN header, which prevents a CPU_FAN warning. It's optional but desirable -...
Forum: Cooling 02-13-2019, 10:16 PM
Replies: 23
Views: 349
Posted By DevBiker
So ... the Platinum coolers support LL fans. That...

So ... the Platinum coolers support LL fans. That means that you can definitely power up to 32 LEDs on the fans from the cooler's LED controller. I wouldn't recommend going above that - I'm not sure...
Forum: Corsair Link 02-13-2019, 09:12 AM
Replies: 7
Views: 122
Posted By DevBiker
Yeah, there's nothing that you can do with those...

Yeah, there's nothing that you can do with those and the Corsair system. The best that you can do with these is to get some of the 4 pin RGB splitters. But with the number of fans that you have,...
Forum: Corsair Link 02-13-2019, 08:40 AM
Replies: 1
Views: 69
Posted By DevBiker
Well, it may be the fan hub or it may be one or...

Well, it may be the fan hub or it may be one or more of the fans. Unfortunately, the only way to really find out is to go through some tedious troubleshooting. Before I describe that, though, let's...
Forum: System Builds, Modding, Custom Components, and Picture Gallery 02-13-2019, 08:31 AM
Replies: 4
Views: 160
Posted By DevBiker
Gorgeous! Very nicely done!!

Gorgeous! Very nicely done!!
Forum: Corsair Link 02-13-2019, 08:24 AM
Replies: 7
Views: 122
Posted By DevBiker
You mentioned EKWB RGB fans ... what RGB system...

You mentioned EKWB RGB fans ... what RGB system do they use? 12V or 5V? Do you have pictures of the connector?
Showing results 1 to 25 of 6103

 
Forum Jump

All times are GMT -4. The time now is 08:42 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.