The Corsair User Forums  

Go Back   The Corsair User Forums > Search Forums

Showing results 1 to 25 of 855
Search took 0.05 seconds.
Search: Posts Made By: emissary42
Forum: Memory 12-12-2017, 08:35 PM
Replies: 2
Views: 148
Posted By emissary42
Which obviously is not going to happen, at least...

Which obviously is not going to happen, at least anytime soon.

@Ploutonas: There are some model numbers however, that can only be produced from a single IC type because of their specs. If you are...
Forum: Memory 12-12-2017, 08:14 PM
Replies: 1
Views: 91
Posted By emissary42
DOCP is the ASUS workaround to apply settings...

DOCP is the ASUS workaround to apply settings from an Intel Extreme Memory Profile (XMP) for AMD systems. To improve the success rate, it tends to overcompensate a bit. If your current settings are...
Forum: Memory 12-12-2017, 08:07 PM
Replies: 2
Views: 79
Posted By emissary42
The system did not start even with only one or...

The system did not start even with only one or two of the Ver7.1 modules installed in the recommended slots?

I personally never had any issues with my Corsair Ver7.1 (Powerchip 1Gbit) modules on...
Forum: Memory 12-09-2017, 12:14 PM
Replies: 6
Views: 218
Posted By emissary42
In general Corsair like most other manufacturers...

In general Corsair like most other manufacturers recommends getting a single kit of the chosen overall capacity over mixing kits. This way you dodge the potential risk for compatibility issues from...
Forum: Memory 12-09-2017, 10:22 AM
Replies: 6
Views: 218
Posted By emissary42
The CMD16GX4M4B3200C16-ROG are another one of the...

The CMD16GX4M4B3200C16-ROG are another one of the older kits, this time from the Z170 days. Why do you need 4x4GB? What advantage do you expect from it over 2x8GB?

The kits i suggested make use of...
Forum: Memory 12-09-2017, 03:44 AM
Replies: 2
Views: 138
Posted By emissary42
Since Corsair made it reversible you could remove...

Since Corsair made it reversible you could remove the top cover from the Vengeance RGB, to unblock the light bar for the most part. You just have to be very careful not to scratch the heatspreaders...
Forum: Memory 12-09-2017, 03:32 AM
Replies: 3
Views: 402
Posted By emissary42
Those VCCSA/IO voltages are rather high for...

Those VCCSA/IO voltages are rather high for DDR4-3700. These are probably configured @ AUTO? Values too high/too low both can hurt stability, so i would adjust them manually instead to what your CPU...
Forum: Memory 12-09-2017, 03:23 AM
Replies: 6
Views: 218
Posted By emissary42
The use of the Airflow fan is optional. ...

The use of the Airflow fan is optional.

However the CMD16GX4M4B3600C18 are one of the early 2015 models that were originally designed for X99. I would instead consider something more recent, like...
Forum: Arbeitsspeicher (Memory) 12-03-2017, 07:53 AM
Replies: 4
Views: 131
Posted By emissary42
Funktioniert das inzwischen mit AMD und Intel?...

Funktioniert das inzwischen mit AMD und Intel? Zeig mal einen Screenshot davon bitte, bei mir hatte es mit dem Testsystem nicht geklappt.
Forum: Arbeitsspeicher (Memory) 12-02-2017, 03:35 PM
Replies: 4
Views: 131
Posted By emissary42
Es gibt verschiedene Tools, welche die...

Es gibt verschiedene Tools, welche die programmierten Timings mehr oder weniger komplett auslesen können. Beispiele:

Aida64 > Motherboard > SPD
oder
Thaiphoon Burner > EEPROM > Read SPD

Beide...
Forum: Arbeitsspeicher (Memory) 11-27-2017, 11:30 AM
Replies: 4
Views: 171
Posted By emissary42
Grundsätzlich funktionieren sollte das Kit bei...

Grundsätzlich funktionieren sollte das Kit bei Standardeinstellungen, aber du wirst möglicherweise auch mit manuellen Einstellungen nicht die Spezifikationen erreichen können. Dies ist aber eher ein...
Forum: Arbeitsspeicher (Memory) 11-22-2017, 08:53 AM
Replies: 21
Views: 662
Posted By emissary42
Ja, soweit die Theorie. Manche Boards mögen es...

Ja, soweit die Theorie. Manche Boards mögen es nicht wenn man bestimmte Timings manuell anfässt. Aber das findet man nur durch ausprobieren heraus und ich hab kein MSI X370 hier und das selbst zu...
Forum: Arbeitsspeicher (Memory) 11-22-2017, 07:09 AM
Replies: 21
Views: 662
Posted By emissary42
Da dein Board keine Debug Segmentanzeige hat,...

Da dein Board keine Debug Segmentanzeige hat, kannst du dies zwar nicht nachprüfen, aber vermutlich braucht das Board diese drei Anläufe um die tertiären Timings passend zu trainieren. Wenn du diese...
Forum: Memory 11-21-2017, 10:15 AM
Replies: 3
Views: 402
Posted By emissary42
Vdimm is probably not the issue since the kit is...

Vdimm is probably not the issue since the kit is rated for DDR4-4000 at 1.35V. You might have to manually adjust VCCSA/VCCIO and/or some of the tertiary timings if your board fails to properly train...
Forum: Memory 11-21-2017, 10:13 AM
Replies: 2
Views: 245
Posted By emissary42
The absolute max V the ICs used on that kit are...

The absolute max V the ICs used on that kit are rated for by Samsung is 1.5V. However if you loosen the primary timings a bit, you should be able to reach DDR4-4000 with less than that. For example i...
Forum: Solid State Drives (German) 11-17-2017, 02:28 AM
Replies: 7
Views: 300
Posted By emissary42
Ab welcher Temperatur beginnt die Drosselung bei...

Ab welcher Temperatur beginnt die Drosselung bei der MP500?

MVE = NVMe?
Forum: Memory 11-14-2017, 08:42 PM
Replies: 1
Views: 218
Posted By emissary42
Intels B/H/Q chipsets are locked to the native...

Intels B/H/Q chipsets are locked to the native memory ratio of the processor used, for the Intel Core i7-2600 that would be DDR3-1333. Support for DDR3-1600 is tied to Ivy Bridge processors, with the...
Forum: Memory 11-14-2017, 02:18 AM
Replies: 3
Views: 415
Posted By emissary42
The two memory slot models can support a higher...

The two memory slot models can support a higher max memory frequency by design, that is why even the ATX ASUS ROG Maximux X Apex only has two memory slots.
Forum: Memory 11-12-2017, 09:47 PM
Replies: 3
Views: 415
Posted By emissary42
First off: The memory is probably not the issue...

First off: The memory is probably not the issue here. The Asus Strix Z370-G Gaming is only rated for up to DDR4-4000 by ASUS and you might already have to make manual adjustments to reach that.
...
Forum: Memory 11-11-2017, 10:57 PM
Replies: 1
Views: 254
Posted By emissary42
My Vengeance RGB (CMR32GX4M4C3000C15) had...

My Vengeance RGB (CMR32GX4M4C3000C15) had temperature sensors and i have seen SPD Dumps from Dominator Platinum models with TS support. Also some websites do mention it in their reviews.
Forum: Kühlung (Cooling) 11-03-2017, 09:23 PM
Replies: 4
Views: 242
Posted By emissary42
Der Lochabstand ist für 1156/1155/1150/1151...

Der Lochabstand ist für 1156/1155/1150/1151 identisch.

Laut Produtkseite werden folgende Sockel unterstützt: "AMD: AM2, AM3, FM1, FM2, Intel LGA: 1150, 1151, 1155, 1156, 1366, 2011, 2011-3".
Forum: Arbeitsspeicher (Memory) 11-03-2017, 01:26 AM
Replies: 10
Views: 382
Posted By emissary42
@dagger85: Manche ICs sind bauartbedingt anfällig...

@dagger85: Manche ICs sind bauartbedingt anfällig für einen Rowhammer, während andere vollkommen immun dagegen sind. Solange dein System "sauber" ist, wird sich dies aber wie gesagt nicht praktisch...
Forum: Arbeitsspeicher (Memory) 11-01-2017, 04:57 PM
Replies: 10
Views: 382
Posted By emissary42
Ich rate mal CMX8GX3M2A1600C9 ist das Modul...

Ich rate mal CMX8GX3M2A1600C9 ist das Modul welches die Probleme verursacht und für das dir im MemTest Rowhammer Subtest die Warnung angezeigt wird?


Zeigt keinen Defekt als solchen an, sondern...
Forum: Memory 10-08-2017, 09:27 AM
Replies: 3
Views: 315
Posted By emissary42
The JEDEC standard profile for DDR4-2133 15-15-15...

The JEDEC standard profile for DDR4-2133 15-15-15 should work at 1.2V. Especially a kit with an XMP rating of DDR4-3200 would have lots of voltage headroom at such a low frequency. This might be a...
Forum: Memory 10-06-2017, 12:01 AM
Replies: 6
Views: 640
Posted By emissary42
The BIOS might show the default speed for the...

The BIOS might show the default speed for the modules which is the standard profile for DDR4-2133 and ignore the XMP speed. It is the same with the Max Bandwidth in CPU-Z. However you can check the...
Showing results 1 to 25 of 855

 
Forum Jump

All times are GMT -4. The time now is 07:42 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.